Cli Configuration - Tripp Lite NGI-M08C4POE8-2 Owner's Manual

Notes:
• The SNTP server always replies the UTC current time.
When the Switch receives the SNTP reply time, the Switch will adjust the time with the
•
time zone configuration and then configure the time to the Switch.
If the time server's IP address is not configured, the Switch will not send any SNTP
•
request packets.
If no SNTP reply packets, the Switch will retry every 10 seconds forever.
•
If the Switch has received SNTP reply, the Switch will re-get the time from NTP server
•
every 24 hours.
If the time zone and time NTP server have been changed, the Switch will repeat the
•
query process.
• No default SNTP server.

5.1.3.1. CLI Configuration

Node
enable show time
enable configure terminal
configure time
HOUR:MINUTE:SECOND
configure time date
YEAR/MONTH/DAY
configure time daylight-saving-time
configure no time daylight-saving-time
configure time daylight-saving-time start-
date
(first|second|third|fourth|last)(S
unday|Monday|Tuesday|Wedne
sday|Thursday|Friday|Saturday
) MONTH HOUR
configure time daylight-saving-time end-
date
(first|second|third|fourth|last)(S
unday|Monday|Tuesday|Wedne
sday|Thursday|Friday|Saturday
Command
39
Description
This command displays current time and time
configurations.
This command changes the node to configure
node.
Sets the current time on the Switch.
hour: 0-23
min: 0-59
sec: 0-59
Note: If you configure Daylight Saving Time
after you configure the time, the Switch will
apply Daylight Saving Time.
Sets the current date on the Switch.
year: 1970-
month: 1-12
day: 1-31
This command enables the daylight saving
time.
This command disables daylight saving on the
Switch.
This command sets the start time of the
Daylight Saving Time.
This command sets the end time of the
Daylight Saving Time.