Usb Port - Tripp Lite NGI-M08C4POE8-2 Owner's Manual

SFP
(9~12)
PoE
(1~8)
1000
LNK/ACT

3.4. USB Port

USB device can be inserted for auto firmware up-gradation. Switch auto-checks the firmware
version present in the USB device and upgrades if newer version of Firmware is present.
For example if you are running with Firmware version 1.0.0.S0 you need to upgrade the
firmware to version 1.0.1.S0 then you need to follow these steps.
1. Create a folder with model name in USB (eg: NGI-M08C4POE8-2)
Note: don't add 'A' in folder name.
2. Insert new firmware file in that folder.
Note: There should be only one firmware in that folder. If there are more than one firmware, the
upgrade process will stop.
3. Insert the USB drive into the NGI-M08C4POE8-2's USB port.
4. Switch updates itself to new firmware version, else it will be ignored for following
conditions
- If there are more than one Firmware files existed
- If Firmware version is identical to the image on device
5. After Upgrade Complete or Upgrade Ignored, Switch will download latest running
configuration & syslog files into USB drive by creating a folder with name same as
switch MAC address.
Configuration File Name Format: config_ YYYYMMDDhhmmss.cfg
SYSLOG File Name Format: flash_ YYYYMMDDhhmmss.log
Illuminated SFP port link-up
Blinking Activity (receiving or transmitting data)
Off Port disconnected or link failed
Off No power is feeding
Illuminated Power feeding on PoE port
Illuminated Port is operating in 1000Mbps speed
Off Port is operating in 10/100Mbps speed
Illuminated Ethernet link up
Blinking Activity (receiving or transmitting data)
Off Port disconnected or link failed
25