Vlan Stacking; Cli Configuration - Tripp Lite NGI-M08C4POE8-2 Owner's Manual

L2SWITCH(config-qinq)# active
L2SWITCH(config-qinq)# show
L2SWITCH(config-qinq)# exit
L2SWITCH(config)# vlan-stacking selective-qinq rule2
L2SWITCH(config-qinq)# cvids 30
L2SWITCH(config-qinq)# priority 5
L2SWITCH(config-qinq)# spvid 600
L2SWITCH(config-qinq)# access-ports 3
L2SWITCH(config-qinq)# tunnel-ports 4
L2SWITCH(config-qinq)# active
L2SWITCH(config-qinq)# show
L2SWITCH(config-qinq)# exit
L2SWITCH(config)# vlan-stacking selective-qinq rule3
L2SWITCH(config-qinq)# cvids 40
L2SWITCH(config-qinq)# priority 7
L2SWITCH(config-qinq)# spvid 700
L2SWITCH(config-qinq)# access-ports 3
L2SWITCH(config-qinq)# tunnel-ports 4
L2SWITCH(config-qinq)# active
L2SWITCH(config-qinq)# show
L2SWITCH(config-qinq)# exit
L2SWITCH(config)# interface interface 1/0/4
L2SWITCH(config-if)# vlan-stacking tunnel-tpid index 6
L2SWITCH(config-if)# exit
L2SWITCH(config)# exit
L2SWITCH# show vlan-stacking
L2SWITCH# show vlan-stacking tpid-table
L2SWITCH# show vlan-stacking selective-qinq
Default Setting: VLAN Stacking is disabled.

6.3.7.1 VLAN Stacking

6.3.7.1.1 CLI Configuration

Node
enable show vlan-stacking
enable show vlan-stacking tpid-
inform
enable configure terminal
configure vlan-stacking (disable|port-
based|selective)
configure vlan-stacking tpid-table index
<2-6> value STRINGS
configure interface IFNAME
Command
This command displays the current vlan-stacking
type.
This command displays the TPID configurations.
This command changes the node to configure
node.
This command disable the vlan stacking or
enable the vlan-stacking with port-based or
selective on the switch.
This command configures TPID table.
This command enters the interface configure
124
Description