Table of Contents
Advertisement
A broadcast frame (or a multicast frame for a multicast group that is known by the system) is
duplicated only on ports that are members of the VID (except the ingress port itself), thus
confining the broadcast to a specific domain.
802.1QPort base VLAN
With port-based VLAN membership, the port is assigned to a specific VLAN independent of the
user or system attached to the port. This means all users attached to the port should be members
of the same VLAN. The network administrator typically performs the VLAN assignment. The
port configuration is static and cannot be automatically changed to another VLAN without
manual reconfiguration.
As with other VLAN approaches, the packets forwarded using this method do not leak into other
VLAN domains on the network. After a port has been assigned to a VLAN, the port cannot send
to or receive from devices in another VLAN without the intervention of a Layer 3 device.
The device that is attached to the port likely has no understanding that a VLAN exists. The device
simply knows that it is a member of a subnet and that the device should be able to talk to all other
members of the subnet by simply sending information to the cable segment. The switch is
responsible for identifying that the information came from a specific VLAN and for ensuring that
the information gets to all other members of the VLAN. The switch is further responsible for
ensuring that ports in a different VLAN do not receive the information.
This approach is quite simple, fast, and easy to manage in that there are no complex lookup tables
required for VLAN segmentation. If port-to-VLAN association is done with an application-
specific integrated circuit (ASIC), the performance is very good. An ASIC allows the port-to-
VLAN mapping to be done at the hardware level.
Default Settings
The default PVID is 1 for all ports.
The default Acceptable Frame is All for all ports.
All ports join in the VLAN 1.
Notice: The maximum VLAN group is 4094.
6.3.2.1 VLAN
6.3.2.1.1 CLI Configuration
Node
enable
show vlan
enable
show vlan <1-4094>
enable
configure terminal
configure
vlan <1~4094>
configure
no vlan <1~4094>
Command
This command displays all of the VLAN
configurations.
This command displays the VLAN
configurations.
This command changes the node to configure
node.
This command enables a VLAN and enters the
VLAN node.
This command deletes a VLAN.
103
Description
Advertisement
Table of Contents
