Cli Configuration - Tripp Lite NGI-M08C4POE8-2 Owner's Manual

Start up Time (sec):
When PD has been start up, the Switch will wait Start up time to do PoE Auto Checking.
Default: 60, range: 30-600 sec.
Interval Time (sec):
Device will send checking message to PD each interval time.
Default: 30, range: 10-120sec.
Action:
The action when the failure detection.
All: Send an alarm message to inform the administrator and then reboot the PD.
Alarm: Just send an alarm message to inform the administrator.
None: Keep Ping the remote PD but does nothing further.
Reboot: Cut off the power of the PoE port, make PD rebooted.
6.11.2.1

CLI Configuration

Node Command
enable show pd-alive
enable configure terminal
configure pd-alive
(disable|enable)
configure interface IFNAME
interface pd-alive action
(reboot|alarm|all|none)
interface pd-alive interval <10-
120>
interface pd-alive ip IP_ADDR
interface pd-alive retry-time <1-
5>
interface pd-alive power-off-time
<3-120> startup-time
<30-600>
Description
This command displays the configuration of the PD
Alive Check.
This command changes the node to configure node.
This command disables or enables the global PD
Alive Check for the Switch.
This command enters the interface configure node.
This command configures the action when the system
detects that the host cannot respond the keep-a-live
probe packet.
This command configures the interval to send the
keep-a-live probe packets to check if the host is still
alive for the specific port. Unit: second.
This command configures the Host IP address which
connects to the specific port.
This command configures the retry times when no
response from the host for the keep-a-live probe
packet for the specific port.
This command configures the power-off time and
startup time. Unit: second.
172