Cli Command Concept - Tripp Lite NGI-M08C4POE8-2 Owner's Manual

Input command "enable"
L2SWITCH>enable
Input a valid username and password when below prompt are displayed.
user: admin
password: admin
L2SWITCH#

4.4. CLI Command Concept

Node Command
enable show hostname
configure reboot
eth0 ip address A.B.C.D/M This command configures a static IP and subnet
interface show
acl show
vlan show
The Node type:
enable

Its command prompt is "L2SWITCH#".
It means these commands can be executed in this command prompt.
configure

Its command prompt is "L2SWITCH(config)#".
It means these commands can be executed in this command prompt.
In Enable code, executing command "configure terminal" enter the configure node.
L2SWITCH#configure terminal
eth0

Its command prompt is "L2SWITCH(config-if)#".
It means these commands can be executed in this command prompt.
In Configure code, executing command "interface eth0" enter the eth0 interface node.
L2SWITCH(config)#interface eth0
L2SWITCH(config-if)#
interface

Its command prompt is "L2SWITCH(config-if)#".
It means these commands can be executed in this command prompt.
In Configure code, executing command "interface gigaethernet1/0/5" enter the
interface port 5 node.
Or
Description
This command displays the system's network name.
This command reboots the system.
mask for the system.
This command displays the current port
configurations.
This command displays the current access control
profile.
This command displays the current VLAN
configurations.
28