Port Configuration; Cli Configuration - Tripp Lite NGI-M08C4POE8-2 Owner's Manual

Parameter
PPPoE IA Global Configurations
PPPoE-IA
User-Defined-String
PPPoE IA VLAN
Circuit-ID VLAN
Remote-ID VLAN
Apply
Refresh

6.13.2 Port Configuration

6.13.2.1 CLI Configuration

Node Command
enable show pppoe intermediate-agent
configuration
enable configure terminal
configure interface IFNAME
interface pppoe intermediate-agent
<enable|disable>
interface pppoe intermediate-agent trust
interface pppoe intermediate-agent
format-type <circuit-id|remote-
id><id-string>
interface pppoe intermediate-agent
vendor-tag <keep|replace|strip>
interface pppoe intermediate-agent vlan
VLANLISTS
interface no pppoe intermediate-agent
trust
interface no pppoe intermediate-agent
format-type <circuit-id|remote-
id>
Description
Selects Enable to activate the PPPoE-IA or Disable to deactivate
the PPPoE-IA.
User defined circuit ID string for the PPPoE IA.
Selects Add to increase the PPPoE-IA Vlan or Remove to delete
the PPPoE-IA Vlan.
Selects Add to increase the Circuit-ID Vlan or Remove to delete
the Circuit-ID Vlan.
Selects Add to increase the Remote-ID Vlan or Remove to delete
the Remote-ID Vlan.
Click Apply to take effect the settings.
Click Refresh to begin configuring this screen afresh.
192
Description
This command displays the current
configurations for the PPPoE IA.
This command changes the node to
configure node.
This command enters the interface
configure node.
This command disables / enables the PPPoE
IA on specific interface for the PPPoE IA.
This command setsaphysical
interfaceastrusted port.
This command sets circuit ID or remote ID
string on specific interface for the PPPoE
IA.
This command is used to set the
retransmitting policy of the specific
interface for the PADO/PADS packet.
Default:Keep
This command enables thePPPoE IA on
specific VLANs of interface.
This command setsaphysical interfaceas
untrusted port.
This command removes circuit ID or remote
ID string on specific interface for the PPPoE
IA