Tripp Lite NGI-M08C4POE8-2 Owner's Manual page 290

Parameter
Trap Event State Settings
Port
State
Apply
Refresh
9.1.3 SNMPv3
9.1.3.1 Group Settings
9.1.3.1.1 CLI Configurations
Node Command
enable show snmp group
enable configure terminal
snmp group GROUPNAME
configure noauth (read STRINGS write
STRINGS notify STRINGS)
snmp group GROUPNAME
configure auth (read STRINGS write
STRINGS notify STRINGS)
snmp group GROUPNAME
configure priv (read STRINGS write
STRINGS notify STRINGS)
configure no snmp group GROUPNAME
Description
Selects the range of ports.
Selects the state for the ports..
Click Apply to take effect the settings.
Click Refresh to begin configuring this screen afresh.
This command displays all snmp v3 groups.
This command changes the node to configure
node.
Configures v3 group of non- authentication.
Configures v3 group of authentication.
Configures v3 group of authentication and
encryption.
This command removes a v3 group from
switch.
290
Description