Bandwidth Limitation; Cli Configuration - Tripp Lite NGI-M08C4POE8-2 Owner's Manual

6.1.2.2 Bandwidth Limitation

The rate limitation is used to control the rate of traffic sent or received on a network interface.
Rate Limitation unit: Mbps.
Default Settings
All ports' Ingress and Egress rate limitation are disabled.

6.1.2.2.1 CLI Configuration

Node Command
enable show bandwidth-limit
enable configure terminal
configure bandwidth-limit egress
RATE_LIMIT ports
PORTLISTS
configure no bandwidth-limit egress
ports PORTLISTS
configure bandwidth-limit ingress
RATE_LIMIT ports
PORTLISTS
configure no bandwidth-limit ingress
ports PORTLISTS
Example:
L2SWITCH#configure terminal
L2SWITCH(config)#bandwidth-limit ingress 1 ports 1-3
Success!
L2SWITCH(config)#exit
L2SWITCH#show bandwidth-limit
Port Ingress
ID rate(Mbs)
---- ---------
1 1
3 1
5 0
7 0
9 0
11 0
This command displays the current rate control
configurations.
This command changes the node to configure
node.
This command enables the bandwidth limit for
outgoing packets and set the limitation.
This command disables the bandwidth limit for
outgoing packets.
This command enables the bandwidth limit for
incoming packets and set the limitation.
This command disables the bandwidth limit for
incoming packets.
Egress Port
rate(Mbs) ID
--------- ----
0 2
0 4
0 6
0 8
0 10
0 12
71
Description
Ingress Egress
rate(Mbs) rate(Mbs)
--------- ---------
1 0
0 0
0 0
0 0
0 0
0 0