Port -Based Q- In -Q - Tripp Lite NGI-M08C4POE8-2 Owner's Manual

Tunnel TPID Index
Tunnel TPID Index
Configures the Port TPID:
Port
Tunnel TPID Index
Apply
Refresh
Action
6.3.7.2 Port-Based Q-in-Q
6.3.7.2.1 CLI Configuration
Node Command
enable show vlan-stacking
portbased-qinq
enable configure terminal
configure interface IFNAME
interface vlan-stacking port-based
priority <0~7>
interface vlan-stacking port-based role
(tunnel|access|normal)
interface vlan-stacking port-based
spvid <1~4096>
interface vlan-stacking tunnel-tpid
index <1-6>
configure interface range
gigabitethernet1/0/PORTLIS
TS
if-range vlan-stacking port-based
priority <0~7>
if-range vlan-stacking port-based role
(tunnel|access|normal)
if-range vlan-stacking port-based
spvid <1~4096>
if-range vlan-stacking tunnel-tpid
index <1-6>
Selects the table index.
Selects the table index.
Selects a port or a range of ports which you want to configure.
Configures the index of the TPID Table for the specific ports.
Click Apply to take effect the settings.
Click Refresh to begin configuring this screen afresh.
Click Delete to delete the MAC VLAN profile.
This command displays the port-based q-in-Q
configurations.
This command changes the node to configure
node.
This command enters the interface configure
node.
This command sets the priority in port based Q-
in-Q.
This command sets VLAN stacking port role.
This command sets the service provider's VID of
the specified port.
This command sets TPID for a Q-in-Q tunnel
port.
This command enters the if-range configure
node.
This command sets the priority in port based Q-
in-Q.
This command sets VLAN stacking port role.
This command sets the service provider's VID of
the specified port.
This command sets TPID for a Q-in-Q tunnel
port.
126
Description