Tripp Lite NGI-M08C4POE8-2 Owner's Manual page 265

7.4.2.1 CLI Configurations
Node Command
enable show port-security
enable configure terminal
configure interface IFNAME
interface port-security mac-
address sticky
MACADDR vlan
<1-4094>
interface no port-security
mac-address sticky
MACADDR vlan
<1-4094>
interface port-security mac-
address sticky
interface no port-security
mac-address sticky
config interface range
gigabitethernet1/0/
PORTLISTS
if-range port-security mac-
address sticky
if-range no port-security
mac-address sticky
The procedures to enable port security with sticky MAC addresses on a port:
To enable the global Port-Security.

L2SWITCH(config)#port-security enable
To select the port you want to configure.

L2SWITCH(config)#interface gigabitethernet1/0/5
To enable the port Port-Security.

L2SWITCH(config-if)#port-security enable
To enable the sticky on the port.

L2SWITCH(config-if)#port-security mac-address sticky
Description
This command displays the current port security
configurations.
This command changes the node to configure node.
This command enters the interface configure node.
This command configures a sticky MAC with a
VLAN on the specific port.
This command removes a sticky MAC with a VLAN
for the specific port from the MAC table.
This command enables the stick function on the
specific port.
This command disables the stick function on the
specific port.
This command enters the if-range configure node.
This command enables the stick function on the
specific ports.
This command disables the stick function on the
specific ports.
265