Cli Configuration - Tripp Lite NGI-M08C4POE8-2 Owner's Manual

DHCP Server:
Application-2 (Local in different VLANs)

The DHCP cleint-1 and DHCP client-2 are located in different VLAN. But they allocate IP
address from the same DHCP server.
1 2
Server client
VLAN 1: port 1,2 (Management VLAN)
VLAN 2: port 3, 4
VLAN 3: port 5, 6
VLAN 4: port 7, 8
DHCP Server  Port 1.
DHCP Client  Port 2, 3, 4, 5, 6, 7, 8.
Result: Hosts connected to port 2,3,4,5,6,7,8 can get IP from DHCP server.
Notes:
• The DHCP Server must connect to the management VLAN member ports.
• The DHCP Relay in management VLAN should be enabled.
Default Settings
The default global DHCP relay state is disabled.
The default VLAN DHCP relay state is disabled for all VLANs.
The default DHCP server is 0.0.0.0
6.5.1

CLI Configuration

Node Command
enable show dhcp relay
enable configure terminal
configure dhcp relay (disable |
enable)
configure dhcp relay vlan
VLAN_RANGE
configure no dhcp relay vlan
Switch DHCP Relay Agent
3 4 5
client client client
Description
This command displays the current configurations for
the DHCP relay.
This command changes the node to configure node.
This command disables/enables the DHCP relay on the
switch.
This command enables the DHCP relay function on a
VLAN or a range of VLANs.
This command disables the DHCP relay function on a
140
6 7 8
client client client