Cli Configuration - Tripp Lite NGI-M08C4POE8-2 Owner's Manual

Fast POE
This feature switches on power without waiting for IOS to boot up. When poe-ha is enabled
on a particular port, the switch on a recovery after power failure, provides power to the
connected endpoint devices within short duration before even the IOS forwarding starts up.
6.11.1.1

CLI Configuration

Node
enable show poe
enable configure terminal
configure poe (disable | enable)
configure poe perpetual
(enable|disable)
configure poe fast (enable|disable)
configure poe total-power
configure interface IFNAME
interface poe (disable|enable)
interface poe priority(critical|high|low)
Command
169
Description
This command displays the PoE
configurations and status.
This command changes the node to configure
node.
This command disables or enables the global
PoE for the Switch.
This command disables or enables the PoE
perpetual mode for the Switch.
This command disables or enables the fast
PoE for the Switch.
This command configures the total power
which the Switch can support.
This command enters the interface configure
node.
This command enables or disables the PoE
function on the specific port.
This command configures the priority of the
PoE function for the specific port.
critical : The highest priority.

high : The middle priority.

low : The lowest priority.
