Gui Login - Tripp Lite NGI-M08C4POE8-2 Owner's Manual

In Configure code, executing command "interface fastethernet1/0/5" enter the
interface port 5 node.
Note: depend on your port speed, gigaethernet1/0/5 for gigabit Ethernet ports and
fastethernet1/0/5 for fast Ethernet ports.
L2SWITCH(config)#interface gigaethernet1/0/5
L2SWITCH(config-if)#
vlan

Its command prompt is "L2SWITCH(config-vlan)#".
It means these commands can be executed in this command prompt.
In Configure code, executing command "vlan 2" enter the vlan 2 node.
Note: where the "2" is the vlan ID.
L2SWITCH(config)#vlan 2
L2SWITCH(config-vlan)#
acl

Its command prompt is "L2SWITCH(config-acl)#".
It means these commands can be executed in this command prompt.
In Configure code, executing command "access-list test" enter the access-list test node.
Note: where the "test" is the profile name.
L2SWITCH(config)#access-list test
L2SWITCH(config-acl)#

4.5. GUI Login

Parameter
User ID
Password
Default:
Username: admin
Password: admin
Description
Enter the user name.
Enter the password.
29