Cli Configuration 6.3.7.2.2 Web Configuration 6.3.7.3 Selective Q- In -Q; Cli Configuration - Tripp Lite NGI-M08C4POE8-2 Owner's Manual

6.3.7.3 Selective Q-in-Q

6.3.7.3.1 CLI Configuration

Node Command
enable show vlan-stacking selective-
qinq
enable configure terminal
configure vlan-stacking (disable|port-
based|selective)
configure vlan-stacking selective-qinq
STRINGS
configure no vlan-stacking selective-
qinq STRINGS
qinq active
qinq inactive
qinq cvid <1-4094>
qinq spvid <1-4094>
qinq priority <0-7>
qinq access-ports PORTLISTS
qinq tunnel-ports PORTLISTS
qinq end
qinq exit
qinq show
Description
This command displays the selective Q-in-Q
configurations.
This command changes the node to configure
node.
This command disables the vlan stacking or
enables the vlan-stacking with port-based or
selective on the switch.
This command creates a selective Q-in-Q profile
with the name.
This command removes the selective Q-in-Q
profile with the name.
This command enables the selective Q-in-Q
profile.
This command disables the selective Q-in-Q
profile.
This command specifies the customer's VLAN
range on the incoming packets.
This command sets the service provider's VLAN
ID for outgoing packets in selective Q-in-Q.
This command sets priority in selective Q-in-Q.
This command specifies the access ports to apply
the rule.
This command specifies the tunnel ports to apply
the rule.
The command exits the CLI Q-in-Q node and
enters the CLI enable node.
The command exits the CLI Q-in-Q node and
enter the CLI configure node.
The command shows the current selective Q-in-
Q profile configurations.
128