Poe Schedule; Cli Configuration - Tripp Lite NGI-M08C4POE8-2 Owner's Manual

6.11.4 PoE Schedule

The function has a global state configuration. If the global state configuration is disabled. The
Switch will not perform the schedule function. If the global state is enabled, the Switch will check
every port's configurations.
If the port's check configuration is NO for a specific day, the Switch will not perform action for
the specific port. If the port's check configuration is YES for a specific day, the Switch will check
the Start time and End Time. If the current time is in the interval between Start time and End
Time, the Switch will perform the action configuration. If the action is ENABLE, the Switch will
send power to the port. If the current time is not in the interval between Start time and End Time,
the Switch will not send power to the port.

6.11.4.1 CLI Configuration

Node Command
enable show poe schedule port
PORT_ID
enable configure terminal
configure interface IFNAME
interface poe schedule (disable|enable)
interface poe schedule week
(Sun|Mon|Tue|Wed|Thu|Fri|Sat)
check (yes|no)
interface poe schedule week
(Sun|Mon|Tue|Wed|Thu|Fri|Sat)
start-time VALUE end-time
VALUE action (enable|disable)
Description
This command displays the PoE port schedule
configurations.
This command changes the node to configure
node.
This command enters the interface configure
node.
This command disables or enables the PoE
schedule on the specific port.
This command enables or disables the PoE
schedule on the specific day.
This command configures the PoE schedule
start-time and end-time on a specific day on the
specific port. Users can enable or disable the
PoE on the time period.
176