Tripp Lite NGI-M08C4POE8-2 Owner's Manual page 284

Parameter
SNMP State
System Name
System Location
System Contact
Apply
Refresh
9.1.1.2 Community Name
9.1.1.2.1 CLI Configurations
Node Command
enable show snmp
enable configure terminal
configure snmp community
STRING (ro|rw)
trusted-host IPADDR
9.1.1.2.2 Web Configurations
Description
Select Enable to activate SNMP on the Switch.
Select Disable to not use SNMP on the Switch.
Type a System Name for the Switch.
(The System Name is same as the host name)
Type a System Location for the Switch.
Type a System Contact for the Switch.
Click Apply to take effect the settings.
Click Refresh to begin configuring this screen afresh.
This command displays the SNMP configurations.
This command changes the node to configure node.
This command configures the SNMP community name.
284
Description