Port Parameters; Cli Configurations - Tripp Lite NGI-M08C4POE8-2 Owner's Manual

root switch. If all switches have the same priority, the switch with the lowest
MAC address will then become the root switch.
Enter a value from 0~61440.
The lower the numeric value you assign, the higher the priority for this bridge.
Priority determines the root bridge, which in turn determines the Root Hello
Time, Root Maximum Age and Root Forwarding Delay.
Path cost is the cost of transmitting a frame on to a LAN through that port. It
Path cost is recommended to assign this value according to the speed of the bridge. The
slower the media, the higher the cost.
Apply Click Apply to take effect the settings.
Refresh Click Refresh to begin configuring this screen afresh.

6.15.2 Port Parameters

6.15.2.1 CLI Configurations

Node Command
enable show spanning-tree blocked
ports
enable show spanning-tree port detail
PORT_ID
enable configure terminal
configure interface IFNAME
interface spanning-tree (disable|enable)
interface spanning-tree bpdufilter
(disable|enable)
interface spanning-tree bpduguard
(disable|enable)
interface spanning-tree rootguard
(disable|enable)
interface spanning-tree edge-port
(disable|enable)
interface spanning-tree cost VALUE
interface no spanning-tree cost
interface spanning-tree port-priority <0-
240>
interface no spanning-tree port-priority
Description
This command displays the spanning tree
information for only blocked port(s).
This command displays the spanning tree
information for the interface port.
This command changes the node to configure
node.
This command enters the interface configure
node.
This command configures enables/disables the
STP function for the specific port.
This command configures enables/disables the
bpdu filter function for the specific port.
This command configures enables/disables the
bpdu guard function for the specific port.
This command enables/disables the BPDU
Root guard port setting for the specific port.
This command enables/disables the edge port
setting for the specific port.
This command configures the cost for the
specific port.
Cost range:
16-bit based value range 1-65535,
32-bit based value range 1-200000000.
This command configures the path cost to
default for the specific port.
This command configures the port priority for
the specific port.
Default: 128.
This command configures the port priority to
209