Tripp Lite NGI-M08C4POE8-2 Owner's Manual page 257

Default Settings
The default global 802.1x state is disabled.
The default 802.1x Authentication Method is local.
The default port 802.1x state is disabled for all ports.
The default port Admin Control Direction is both for all ports.
The default port Re-authentication is disabled for all ports.
The default port Control Mode is auto for all ports.
The default port Guest VLAN is 0 for all ports. (Guest VLAN is disabled).
The default port Max-req Time is 2 times for all ports.
The default port Reauth period is 3600 seconds for all ports.
The default port Quiet period is 60 seconds for all ports.
The default port Supp timeout is 30 seconds for all ports.
The default port Server timeout is 30 seconds for all ports.
7.3.1 Global Settings
7.3.1.1 CLI Configurations
Node
enable show dot1x
enable show dot1x username
enable show dot1x accounting-record
enable configure terminal
configure dot1x authentication (disable|enable) This command enables/disables the 802.1x
configure dot1x authentic-method
(local|radius)
configure no dot1xauthentic-method
configure dot1x accounting (disable|enable)
configure dot1x accounting-clean
configure dot1x default
configure dot1x guest-vlan <1-4094>
configure no dot1x guest-vlan
configure dot1x radius primary-server-ip <IP>
port PORTID
configure dot1x radius primary-server-ip <IP>
port PORTID key KEY
configure no dot1x radius primary-server-ip
configure dot1x radius secondary-server-ip
Command
257
Description
This command displays the current 802.1x
configurations.
This command displays the current user
accounts for the local authentication.
This command displays the local accounting
records.
This command changes the node to
configure node.
authentication on the switch.
This command configures the authentic
method of802.1x.
This command configures the authentic
method of 802.1x to default.
This command enables/disables the dot1x
local accounting records.
This command cleans all of the accounting
records.
This command sets all of the configuration
to default settings.
This command configures the guest vlan.
This command removes the guest vlan.
This command configures the primary
radius server.
This command configures the primary
radius server.
This command removes the secondary
radius server.
This command configures the secondary