Tripp Lite NGI-M08C4POE8-2 Owner's Manual page 199

<IPv4_ADDR><MAC_ADDR> from ARP table.
configure no ipv6 arp
<IPv6_ADDR><MAC_ADDR>
configure interface vlan VLAN-ID
L3 ipv4 address A.B.C.D/M
interface
L3 ipv6 address <IPv6_ADDR>/M
interface
L3 no ipv4 address A.B.C.D/M
interface
L3 no ipv4 address
interface <IPv6_ADDR>/M
L3 ipv4 route A.B.C.D/M A.B.C.D
interface
L3 ipv6 route <IPv6_ADDR>/M
interface <IPv6_ADDR>
L3 no ipv4 route A.B.C.D/M
interface A.B.C.D
L3 no ipv6 route<IPv6_ADDR>/M
interface <IPv6_ADDR>
Example:
IP Forwarding Enable: This command is used to enable ip forwarding (routing).

L2SWITCH(config)#ip forwarding enable
IP Forwarding Disable: This command is used to disable ip forwarding.

This command deletes a static IPv6 ARP entry
from ARP table.
This command enters the L3 interface node.
This command assigns a specified IPv4
interface route to the interface.
We can assign multiple IPv4 interface route to
a single interface with different IP segment.
If this configuration is a first IP assigning to
the interface then automatically interface is
enabled for routing.
This command assigns a specified IPv6
interface route to the interface.
We can assign only one IPv6 interface route
for an interface vlan.
If this configuration is a first IP assigning to
the interface then it automatically enables the
interface with routing.
This command deletes a specified IPv4
interface route from the interface vlan.
This command deletes all dependent static
routes on the specified IPv4 interface route.
If there is no assigned IP addresses for the
specified interface after deleting then it will
automatically disables routing in interface.
This command deletes a specified IPv6
interface route from the interface.
This command deletes all dependent static
routes on the specified IPv6 interface route.
If there is no assigned IP addresses for the
specified interface after deleting then it will
automatically disables routing in interface
vlan.
This command configures anIPv4 static route
onto the specified interface vlan.
This command configures anIPv6 static route
onto the specified interface vlan.
This command deletes a specified IPv4 static
route from an interface vlan.
This command deletes a specified IPv6 static
route from an interface vlan.
199