Tripp Lite NGI-M08C4POE8-2 Owner's Manual page 285

Parameter
Community Name Settings
Community String
Rights
Network ID of
Trusted Host
Mask
Apply
Refresh
Community Name List
Action
9.1.2 SNMP Trap
9.1.2.1 Trap Receiver
9.1.2.1.1 CLI Configurations
Node Command
enable show snmp
enable configure terminal
configure snmp trap-receiver
IPADDR (v1|v2c)
COMMUNITY
configure snmp trap-ipv6-
receiver IPADDR
(v1|v2c)
COMMUNITY
Description
Enter a Community string, this will act as a password for requests from
the management station.
An SNMP community string is a text string that acts as a password. It
is used to authenticate messages that are sent between the management
station (the SNMP manager) and the device (the SNMP agent). The
community string is included in every packet that is transmitted
between the SNMP manager and the SNMP agent.
Select Read-Only to allow the SNMP manager using this string to
collect information from the Switch.
Select Read-Write to allow the SNMP manager using this string to
create or edit MIBs (configure settings on the Switch).
Type the IP address of the remote SNMP management station in dotted
decimal notation, for example 192.168.1.0.
Type the subnet mask for the IP address of the remote SNMP
management station in dotted decimal notation, for example
255.255.255.0.
Click Apply to take effect the settings.
Click Refresh to begin configuring this screen afresh.
Click Delete to remove a specific Community String.
This command displays the SNMP configurations.
This command changes the node to configure node.
This command configures the trap receiver's
configurations, including the IP address, version (v1 or
v2c) and community.
This command configures the trap IPv6 receiver's
configurations, including the IP address, version (v1 or
v2c) and community.
285
Description