Web Configuration - Tripp Lite NGI-M08C4POE8-2 Owner's Manual

6.8.2.2 Web Configuration

Parameter Description
LACP Settings
Select Enable from the drop down box to enable Link Aggregation
State Control Protocol (LACP).
Select Disable to not use LACP.
LACP system priority is a number between 1 and 65,535. The switch with
the lowest system priority (and lowest port number if system priority is
the same) becomes the LACP "server". The LACP "server" controls the
System Priority
operation of LACP setup. Enter a number to set the priority of an active
port using Link Aggregation Control Protocol (LACP). The smaller the
number, the higher the priority level.
Select a trunk group ID and then select whether to Enable or Disable
Group LACP
Group Link Aggregation Control Protocol for that trunk group.
Port Priority Select a port or a range of ports to configure its (their) LACP priority.
Apply Click Apply to take effect the settings.
155