Cli Configuration - Tripp Lite NGI-M08C4POE8-2 Owner's Manual

6.8.2.1 CLI Configuration

Node Command
enable show lacp counters
[GROUP_ID]
enable show lacp port_priority
enable show lacp sys_id
enable configure terminal
configure lacp (disable | enable)
configure lacp GROUP_ID
(disable | enable)
configure clear lacp counters
[PORT_ID]
configure lacp system-priority <1-
65535>
configure no lacp system-priority
configure interface IFNAME
interface lacp port_priority <1-
65535>
interface no lacp port_priority
configure interface range
gigabitethernet1/0/POR
TLISTS
if-range lacp port_priority <1-
65535>
if-range no lacp port_priority
Description
This command displays the LACP counters for the
specific group or all groups.
This command c displays the port priority for the
LACP.
This command displays the actor's and partner's
system ID.
This command changes the node to configure node.
This command disables / enables the LACP on the
switch.
This command disables / enables the LACP on the
specific trunk group.
This command clears the LACP statistics for the
specific port or all ports.
This command configures the system priority for the
LACP. Note: The default value is 32768.
This command configures the default for the system
priority for the LACP.
This command enters the interface configure node.
This command configures the priority for the specific
port.
Note: The default value is 32768.
This command configures the default for the priority
for the specific port.
This command enters the if-range configure node.
This command configures the priority for the specific
ports.
Note: The default value is 32768.
This command configures the default for the priority
for the specific ports.
154