Table of Contents
Advertisement
Parameter
Description
ARP Inspection Settings
Use this to Enable or Disable ARP inspection on the Switch.
State
Enter the VLAN IDs you want the Switch to enable ARP Inspection
VLAN State
for. You can designate multiple VLANs individually by using a
comma (,) and by range with a hyphen (-).
Select the ports which are trusted and deselect the ports which are un-
trusted.
The Switch does not discard ARP packets on trusted ports for any
reason.
The Switch discards ARP packets on un-trusted ports in the following
Trusted Ports
situations:
• The sender's information in the ARP packet does not match any of
the current bindings.
• The rate at which ARP packets arrive is too high. You can specify the
maximum rate at which ARP packets can arrive on un-trusted ports.
Select All
Click this to set all ports to trusted.
Deselect All
Click this to set all ports to un-trusted.
Apply
Click Apply to take effect the settings.
Refresh
Click Refresh to begin configuring this screen afresh.
ARP Inspection Status
ARP Inspection
This field displays the current status of the ARP Inspection feature,
State
Enabled or Disabled.
This field displays the VLAN IDs that have ARP Inspection enabled
Enabled on VLAN
on them. This will display None if no VLANs have been set.
This field displays the ports which are trusted. This will display
Trusted Ports
None if no ports are trusted.
246
Advertisement
Table of Contents
