Web Configuration - Tripp Lite NGI-M08C4POE8-2 Owner's Manual

6.9.2

Web Configuration

Parameter Description
Loop Detection Settings
State Select this option to enable loop guard on the Switch.
Enter the destination MAC address the probe packets will be sent to.
MAC Address
If the port receives these same packets the port will be shut down.
Port Select a port on which to configure loop guard protection.
Select Enable to use the loop guard feature on the Switch.
State
Select Enable to reactivate the port automatically after the designated
Recovery State
recovery time has passed.
Specify the recovery time in minutes that the Switch will wait before
Recovery Time
reactivating the port. This can be between 1 to 60 minutes.
Apply Click Apply to take effect the settings.
160