Port Settings; Cli Configurations - Tripp Lite NGI-M08C4POE8-2 Owner's Manual

Parameter
DHCP Snooping Settings
State
VLAN State
Apply
Refresh
DHCP Snooping Status
DHCP Snooping
State
Enabled on VLAN

7.1.1.2 Port Settings

7.1.1.2.1 CLI Configurations

Node Command
enable show dhcp-snooping
enable configure terminal
configure interface IFNAME
interface dhcp-snooping host count
<1-32>
interface no dhcp-snooping host count
interface dhcp-snooping trust
interface no dhcp-snooping trust
configure interface range
gigabitethernet1/0/PORTLISTS
Description
Select Enable to use DHCP snooping on the Switch. You still have to
enable DHCP snooping on specific VLANs and specify trusted ports.
Note: The Switch will drop all DHCP requests if you enable DHCP
snooping and there are no trusted ports.
Select Disable to not use DHCP snooping.
Select Add and enter the VLAN IDs you want the Switch to enable
DHCP snooping on. You can designate multiple VLANs individually
by using a comma (,) and by range with a hyphen (-).
Select Delete and enter the VLAN IDs you no longer want the Switch
to use DHCP snooping on.
Click Apply to take effect the settings.
Click Refresh to begin configuring this screen afresh.
This field displays the current status of the DHCP snoopingfeature,
Enabled or Disabled.
This field displays the VLAN IDs that have DHCP snooping enabled
on them. This will display None if no VLANs have been set.
This command displays the current DHCP
snooping configurations.
This command changes the node to configure
node.
This command enters the interface configure
node.
This command configures the maximum host
count for the specific port.
This command configures the maximum host
count to default for the specific port.
The default host count is 32.
This command configures the trust port for the
specific port.
This command configures the un-trust port for
the specific port.
This command enters the if-range configure
node.
238
Description