Table of Contents
Advertisement
Parameter
Description
Port Settings
Port
Select a port or a range ports you want to configure on this screen.
State
Select Enable to activate the port or Disable to deactivate the port.
Select the speed and duplex mode of the port. The choices are:
• Auto
• 10 Mbps / Full Duplex
Speed/Duplex
• 10 Mbps / Half Duplex
• 100 Mbps / Full Duplex
• 100 Mbps / Half Duplex
• 1000 Mbps / Full Duplex
Select On to enable access to buffering resources for the port thus ensuring
lossless operation across network switches. Otherwise, select Off to disable
Flow Control
it.
Click Apply to take effect the settings.
Apply
Refresh
Click Refresh to begin configuring this screen afresh.
Port Status
Port
This field displays the port number.
State
This field displays whether the port is enabled or disabled.
This field displays the speed either 10M, 100Mor 1000Mand the duplex
Speed/Duplex
mode Full or Half.
Flow Control
This field displays whether the port's flow control is On or Off.
This field displays the link status of the port. If the port is up, it displays the
Link Status
port's speed, duplex and flow control setting. Otherwise, it displays Link
Down if the port is disabled or not connected to any device.
5.4.2. Information
5.4.2.1. CLI Configuration
Node
Command
enable
show interface IFNAME
enable
configure terminal
configure interface IFNAME
interface
show
interface
description STRING
Description
This command displays the current port
configurations.
This command changes the node to
configure node.
This command enters the interface
configure node.
This command displays the current port
configurations.
This command configures a description
for the specific port. The length of
56
Advertisement
Table of Contents
