Pd Alive Check - Tripp Lite NGI-M08C4POE8-2 Owner's Manual

Apply
Refresh
PoE Status
State
Fast PoE
Perpetual PoE
Total Power
Total Consuming
Power
External Power
Module
Port
State
PD Priority
Class
Consuming
Power(mW)
Power
Allocated(mW)
Current Status(mA) Displays the current status for the specific port.

6.11.2 PD Alive Check

The function has a global state configuration. If the global state configuration is enabled. The
Switch will check the configurations of every port.
If the port's state is enabled, the Switch will send keep-a-live probe packet every interval time.
If the host cannot respond when the keep-a-live probe packet count is over the retry times, the
Switch performs the action, reboot/alarm/all to the Power Device, depending on the port's
configuration.
Power OFF Time (sec):
When PD has been rebooted, the PoE port restored power after the specified time.
Default:15, range: 3-120 sec.
Click Apply to take effect the settings.
Click Refresh to begin configuring this screen afresh.
Displays the PoE state for the Switch.
Display the Fast PoE state for the Switch.
Display the Perpetual PoE state for the Switch.
Displays the total power that the Switch supports.
Displays the total consuming power for all of the PDs.
Displays the status of the external power module.
Display the Port No.
Displays the PoE state for the specific port.
Displays the PoE priority for the specific port.
The field displays the class mode which the PSE negotiate with the PD
on the specific port.
Displays the consuming power for the specific port.
Displays the power allocated for the specific port.
171