Tripp Lite NGI-M08C4POE8-2 Owner's Manual page 318

Parameter
Manual Registration Settings
Type
MAC Address
Product Name
System Name
Apply
Refresh
Manual Registration Table
Action
9.8.3 ONVIF
9.8.3.1 CLI Configurations
Node Command
enable show onvif
enable configure terminal
config onvif enable
config onvif tx-interval
<6-3600>
config no onvif enable
config no onvif tx-interval
9.8.3.2 Web Configurations
Description
The kind of devices connected to switch.
The MAC address of the device.
The product name of the device.
The system name of the device.
Click Apply to take effect the settings.
Click Refresh to begin configuring this screen afresh.
Clicks Delete to delete this device.
Description
This command displays the ONVIF configurations.
This command changes the node to configure node.
This command enables the ONVIF on the Switch.
This command configures the tx interval for the
ONVIF.
This command disables the ONVIF on the Switch.
This command reset the tx interval to default for the
ONVIF.(Default: 6 seconds).
318