Assigning A Cross-Point Assign Table; Setting A Source Signal; Setting A Source Name; Setting The Source Color - Sony XVS-G1 User Manual

Assigning a Cross-Point
Assign Table
You can select a cross-point assign table to use for each
switcher bank or bus.
1
Open the Home > Setup > Xpt Assign > Table Assign
menu (19102.11).
2
Select the target switcher bank or bus to set.
To select and set multiple switcher banks/buses, place
a check mark beside the target switcher banks/buses to
set.
To select and set all switcher banks/buses, place a
check mark in the Select All checkbox.
3
Press the [Table Assign] button and select a table
(Main, Table1 to Table14) from the pull-down list.

Setting a Source Signal

Note
Source signals "Primary 45 to 48" cannot be used. All
settings are disabled.

Setting a Source Name

You can set the name of a source signal.
1
Open the Home > Setup > Xpt Assign > Src Name/Src
Color > Edit Src Name/Color menu (19102.51).
2
Select the target source signal to set.
To select and set multiple source signals, place a check
mark beside the target source signals to set.
To select and set all source signals, place a check mark
in the Select All checkbox.
3
Press the [Source Name] button and enter a source
name (up to 16 characters) using the keyboard.
Note
When multiple source signals are selected,
consecutively numbered source names are set.
For details, see "Name settings when multiple items
are selected" (page 43).

Setting the Source Color

You can set the color displayed for 3rd row/4th row
buttons and cross-point indicators in the cross-point
control block.
1
Open the Home > Setup > Xpt Assign > Src Name/Src
Color > Edit Src Name/Color menu (19102.51).
2
Select the target source signal to set.
To select and set multiple source signals, place a check
mark beside the target source signals to set.
To select and set all source signals, place a check mark
in the Select All checkbox.
3
Press the [Source Color] button and select a source
color (User Color 1 to User Color 8) from the pull-
down list.
303