Setting A Router; Assigning A Destination; Assigning A Source Table; Setting Levels - Sony XVS-G1 User Manual

Setting a Router

Assigning a Destination

You can assign a destination to a cross-point (destination
selection delegation button).
You can set a source table and operation inhibit settings for
each destination.
Notes
• A source table cannot be selected on buttons with button
numbers 65 to 128.
• Operation inhibit cannot be configured for buttons with
button numbers 65 to 128.
1
Open the Home > Setup > Panel > Router > Delegation
Button Assign menu (19104.51).
A list of delegation buttons to which to assign a
destination is shown on the left and a list of assignable
destinations is shown on the right.
2
In the list on the left, select the target button to set.
You can also press the [Select Button] button and enter
a button number in the numeric keypad window.
3
In the list on the right, select a destination to assign.
You can also press the [Select Destination] button and
enter a destination number in the numeric keypad
window.
4
Press the [Set] button.
To select a source table
Select the target button to set and select a source table
(Table 1 to Table 5) in the [Source Table] group.
To inhibit operation of buttons
Select the target button and set the [Inhibit] button to the
on state.
Setting the recall target for a snapshot
You can set whether a destination is the recall target when
a snapshot of the router is recalled.
Note
When operation inhibit is enabled, destination recall is not
available.
1
Open the Home > Setup > Panel > Router > Delegation
Button Assign menu (19104.51).
2
In the list on the left, select the target button to set.
You can also press the [Select Button] button and enter
a button number in the numeric keypad window.
3
Set the [Snapshot Enable] button to the on state.

Assigning a Source Table

You can set five types of source table.
You can assign a source to a cross-point (source selection
delegation button) for each source table.
1
Open the Home > Setup > Panel > Router > Source
Table Assign menu (19104.52).
2
Display the target source table to set.
Select a tab to change the source table (Src Table1 to
Src Table5) to display.
A list of delegation buttons to which to assign a source
is shown on the left and a list of assignable sources is
shown on the right.
3
In the list on the left, select the target button to set.
You can also press the [Select Button] button and enter
a button number in the numeric keypad window.
4
In the list on the right, select a source to assign.
You can also press the [Select Source] button and enter
a source number in the numeric keypad window.
5
Press the [Set] button.
To inhibit operation of buttons
Select the target button and set the [Inhibit] button to the
on state.

Setting Levels

You can set the enable level for each of the level selection
buttons 1 to 4.
1
Open the Home > Setup > Panel > Router > Level
Button Assign menu (19104.53).
2
Select the target level selection button (1 to 4) to set.
3
Press the [Edit] button for [Level Assign].
The [Enable Level] window appears.
4
Place a check mark in the levels (1 to 8) to enable.
5
Press [OK].
323