Setting The Default Gateway - Sony XVS-G1 User Manual

To set an interface other than standard interface
1 (STD 1)
1
Open the System Configuration > Network > Network
Settings menu (20201.11).
2
Select the target network interface to set.
3
Press the [Edit] button.
A setup window for the selected network interface
appears.
4
Press the [LAN] button and select a LAN to set from
the pull-down list.
The types of LAN which can be set will vary
depending on the selected network interface.
When a LAN for redundancy is selected
The same settings as the main LAN are applied.
Proceed to step 11.
5
Press the [Mode] button for [IPv4] and select a setup
mode from the pull-down list.
Off: Do not use IPv4.
Manual: Set manually.
DHCP: Set automatically using DHCP.
When [Off] or [DHCP] is selected, proceed to step 8.
6
Press the [Address] button for [IPv4] and enter an
address using the keyboard.
7
Press the [Prefix Length] button for [IPv4] and enter a
prefix length in the numeric keypad window.
8
Press the [Mode] button for [IPv6] and select a setup
mode from the pull-down list.
Off: Do not use IPv6.
Manual: Set manually.
Auto: Set automatically using RA (Router
Advertisement).
DHCP: Set automatically using DHCP.
When [Off], [Auto], or [DHCP] is selected, proceed to
step 11.
9
Press the [Address] button for [IPv6] and enter an
address using the keyboard.
10
Press the [Prefix Length] button for [IPv6] and enter a
prefix length in the numeric keypad window.
11
Press [OK].
12
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button, check the message, then press
[OK].
13
Check the message, then press [OK].

Setting the Default Gateway

1
Open the System Configuration > Network > Network
Settings menu (20201.11).
2
Press the [Edit] button in the [Default Gateway] group.
The [Default Gateway] window appears.
3
Press the [LAN] button for [IPv4] and select the target
LAN to set from the pull-down list.
Select [Ctrl LAN], [Util LAN1], [Util LAN2], [User
LAN1], or [User LAN2].
When not using the IPv4 default gateway, select [No
Assign].
The [Mode] setting for [IPv4] is linked to the selected
LAN setting. When set to [Off] or [DHCP], proceed to
step 5.
4
Press the [Address] button for [IPv4] and enter an
address using the keyboard.
5
Press the [LAN] button for [IPv6] and select the target
LAN to set from the pull-down list.
Select [Util LAN1], [Util LAN2], [User LAN1], or
[User LAN2].
When not using the IPv6 default gateway, select [No
Assign].
The [Mode] setting for [IPv6] is linked to the selected
LAN setting. When set to [Off], [Auto], or [DHCP],
proceed to step 7.
6
Press the [Address] button for [IPv6] and enter an
address using the keyboard.
7
Press [OK].
8
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button, check the message, then press
[OK].
9
Check the message, then press [OK].
358