Setting A Crop; Setting A Wipe Crop - Sony XVS-G1 User Manual

Setting a Crop

1
Open the Home > DME > Channel1 > Edge > Border/
Crop menu (15101.21).
2
Set the [Crop] button to the on state and set the
following parameters.
No. Parameter
1-1 H
1-2 V
1-3 All
2-1 Top
2-2 Left
2-3 Right
2-4 Bottom
a) The entered numeric value is automatically a positive value for the
right and top edges and a negative value for the left and bottom edges.
To soften the edges
Set the [Edge Soft] button to the on state and set the
following parameter.
No. Parameter Adjustment
1 Soft Edge softness
Linking the crop areas when inverting
1
Open the Home > DME > Channel1 > Edge > Border/
Crop menu (15101.21).
2
In the [Invert/Crop Process] group, select the
operation when inverting.
Crop -> Invert: With the axis of symmetry at the
center of the input image, invert both the central
image and the crop area horizontally and vertically
around the axis of symmetry. The order of effect
application for the input image is Crop and then
Invert.
Invert -> Crop: With the axis of symmetry at the
center of the input image, invert only the central
image horizontally and vertically around the axis
of symmetry. The order of effect application is
Invert and then Crop.
Adjustment
Simultaneous adjustment of
a)
crop of left and right edges
Simultaneous adjustment of
crop of top and bottom edges
a)
Simultaneous adjustment of
crop of top, bottom, left, and
a)
right edges
Crop of top edge
Crop of left edge
Crop of right edge
Crop of bottom edge

Setting a Wipe Crop

Note
When Brick is set, Wipe Crop cannot be enabled.
1
Open the Home > DME > Channel1 > Edge > Wipe
Crop menu (15101.22).
2
Set the [Wipe Crop] button to the on state.
3
Press the [Pattern Select] button.
A pattern selection window appears.
4
Set the button for the target wipe crop pattern to the on
state.
Note
The wipe crop patterns are the same as wipe pattern
numbers 1 to 24 and 304.
5
Press [OK].
To invert the wipe crop area (Invert)
You can swap the inner and outer areas of the wipe crop
pattern.
Set the [Invert] button to the on state.
To set the radius of wipe crop pattern corners
(Radius)
You can set the radius of the four corners when pattern
number 304 is selected.
Set the [Radius] button to the on state and set the following
parameter.
No. Parameter
1 Radius
To replicate a wipe crop pattern (Multi)
You can replicate a pattern horizontally, vertically, or both
up to 63 times.
For details about pattern layouts, see "Replicating a wipe
pattern (Multi)" (page 109).
Set the [Multi] button to the on state and set the following
parameters.
No. Parameter
1 H Multi
2 V Multi
3 Invert Type
153
Adjustment
Corner radius
Adjustment
Number of repetitions of pattern
horizontally
Number of repetitions of pattern
vertically
Pattern layout (1 to 4)