Enabling/Disabling An Sdi Output Connector - Sony XVS-G1 User Manual

Notes
• To use the HDR converter function, the XZS-G1750
HDR Converter License (option) is required.
• When the system signal format is 1080P or 1080i, an
HDR converter cannot be used.
1
Open the Home > Setup > System > Output > HDR
Converter menu (19101.46).
The system OETF, color space, and HDR settings are
displayed in [System Settings].
2
Select the target output to set.
To select and set multiple outputs, place a check mark
beside the target outputs to set.
To select and set all outputs, place a check mark in the
Select All checkbox.
3
Press the [Output Signal OETF] button and select an
OETF from the pull-down list.
Select [SDR], [HLG], [PQ], [S-Log3 (HDR)], or
[S-Log3 (Live HDR)].
4
Press the [Color] button and select a color space from
the pull-down list.
Select [BT.709] or [BT.2020].
5
Enable/disable the system settings using the [Follow
System Settings] switch.
On: Enable system settings. Apply the system settings
to the output signal.
Off: Disable system settings. Apply different settings
than the system settings to the output signal.
If the system settings are disabled, press the [Adjust
Details] button and configure the HDR conversion
settings in the [HDR Converter] window.
Note
When multiple outputs are selected, the [Follow
System Settings] switch settings do not change in
unison.
[HDR Converter] window > [Config] tab
Configure in the same way as for an input signal.
For details, see "[HDR Converter] window > [Config]
tab" (page 293).
Note
Only the [Master Black (Abs.)] button and [HDR Black
Offset] button settings are available in the [Black Level]
group for an output signal.
[HDR Converter] window > [Conversion]
tab
Configure in the same way as for an input signal.
For details, see "[HDR Converter] window >
[Conversion] tab" (page 294).
Notes
• This cannot be set when the system OETF and output
signal OETF are set to [SDR].
• When converting from SDR to HDR, configure in the
same way as for an input signal as described in "When
converting from HDR to SDR".
• When converting from HDR to SDR, configure in the
same way as for an input signal as described in "When
converting from SDR to HDR".
[HDR Converter] window > [Additional
Paint] tab
Configure in the same way as for an input signal.
For details, see "[HDR Converter] window > [Additional
Paint] tab" (page 295).
Returning [HDR Converter] window
settings to the initial settings
Press the [Default Recall] button in the [HDR Converter]
window.
The settings on all tabs in the [HDR Converter] window
are returned to the following values.
[Config] tab: System settings values
[Conversion] tab: System settings values
[Additional Paint] tab: Default values
Enabling/Disabling an SDI Output
Connector
You can enable or disable the signal output for an SDI
output connector.
When disabled, no signal is output from the output
connector.
Note
To prevent radio wave interference from occurring,
disable output connectors that do not have a cable
connected.
1
Open the Home > Setup > System > SDI Output
Enable menu (19101.91).
Buttons for the output connectors for boards installed
in each slot are displayed.
299