Setting A Network Aux Remote Panel - Sony XVS-G1 User Manual

5
Press the [Edit] button for [IPv4 Address/Prefix,
Default Gateway].
The [Edit Network] window appears.
6
Press the [Address] button for [IPv4] and enter an
address using the keyboard.
7
Press the [Default Gateway] button for [IPv4] and
enter a default gateway address using the keyboard.
8
Press [OK].
9
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button, check the message, then press
[OK].
10
Check the message, then press [OK].
To identify a control panel
Select the target control panel to set and press the [Send
Beacon] button.
The buttons on the control panel start flashing to identify
the target control panel to set.
Setting a Network AUX
Remote Panel
Network AUX remote panel
A network AUX remote panel is a function that provides a
simple connection of an MKS-R3210/R1620 Remote
Control Panel with a switcher, without using LSM (Live
System Manager), for using the MKS-R3210/R1620 as a
switcher remote panel. You can control the switching of
cross-points on the switcher from a remote panel on the
network.
Network AUX remote panel restrictions
• Up to 16 remote panels can be configured for a single
control panel.
• The network AUX remote panel function is not available
if the MKS-R3210/R1620 Remote Control Panel is
connected to LSM.
• The network AUX remote panel function is not available
if control using the NS-Bus External Control protocol is
enabled.
• The following function and settings restrictions apply to
a remote panel.
Item
Functions
Levels
Operation button colors
Source/destination names Source names set on the
• To use the same cross-point settings as the switcher on a
remote panel, cross-point assign table settings must be
copied to the remote panel.
For details, see "Copying a Table to a Remote Panel"
(page 305).
Setting the MKS-R3210/R1620 Remote Control
Panel
On the Network Settings page of the web menu of the
remote control panel, configure the network (LAN1).
For details about setup, refer to the operating instructions
for the MKS-R3210/R1620.
354
Restrictions
The following functions are
not available.
• Global salvo
• Protect
• Monitor
• Retrace
• Linkage
Only 1 to 8 are available.
Set to "Local"
(Color Settings on the
Display Settings page)
switcher, and fixed bus
names
Alias name selection not
supported
(Alias Name Lists page)