Displaying A Macro Attachment List - Sony XVS-G1 User Manual

Setting the macro attachment
configuration mode of a cross-point button
The following two modes can be selected for a macro
attachment set to a cross-point button.
Button number mode: Assign a macro attachment for the
combination of bus and button number.
Pair number mode: Assign a macro attachment for the
combination of bus and pair number.
Notes
• If the macro attachment configuration mode is changed,
the macro attachment assigned to a cross-point button is
deleted.
• In pair number mode, the following occurs.
- If the same pair number is assigned to multiple cross-
point buttons, pressing any of the buttons executes the
macros of all buttons to which the same pair number is
assigned.
- If the same pair number is assigned to multiple cross-
point buttons, releasing the macro attachment of any of
the buttons releases the macro attachment of all
buttons to which the same pair number is assigned.
- If you change the pair number assignment to a
different cross-point button, the macro attachment
setting is also transferred.
• When macro attachment data is loaded, the button
number mode or pair number mode setting is
overwritten.
1
Open the Home > Register > Macro > Attachment
menu (18307.31).
2
In the [Xpt Attachment Mode] group, select a
configuration mode.
Button Mode: Button number mode
Pair Mode: Pair number mode
3
Check the message, then press [OK].

Displaying a Macro Attachment List

You can check the information for a button/fader lever to
which a macro attachment is set in list view.
1
Open the Home > Register > Macro > Attachment
menu (18307.31).
2
Display the target control block.
Select a tab to change the control block to display.
[M/E-1] tab to [M/E-5] tab, [P/P] tab: Switcher bank
cross-point control block and transition control
block
[Trackball] tab: Device control block
A list of the macro attachments set to the buttons of the
selected control block is displayed.
You can check the following information in a macro
attachment list.
• Block name
Displays the name of the control block on which macro
attachments are set.
• Buttons to which a macro attachment is set
• Register number
• Register name
• Link mode
For details about macro attachment lists, see "Macro
Attachment Lists" (page 384).
Note
Macro attachments set to the following buttons in the
cross-point control block may not be displayed in the list.
• DME utility 1 bus and 2 bus cross-point buttons in utility
bus mode
• DME utility 1 bus and 2 bus cross-point buttons in key/
AUX bus delegation mode
Releasing a macro attachment
1
Open the Home > Register > Macro > Attachment
menu (18307.31).
2
Display the target control block.
Select a tab to change the control block to display.
[M/E-1] tab to [M/E-5] tab, [P/P] tab: Switcher bank
cross-point control block and transition control
block
[Trackball] tab: Device control block
3
Select the target button to release.
To select and release multiple buttons, place a check
mark beside the target buttons to release.
To select and release all buttons, place a check mark in
the Select All checkbox.
4
Press the [Delete] button.
5
Check the message, then press [OK].
Releasing macro attachments on all
control blocks
1
Open the Home > Register > Macro > Attachment
menu (18307.31).
2
Press the [All Clear] button.
252