Setting Parameters - Sony XVS-G1 User Manual

Example:
To select list items 1 to 5, enter "1-5".
To select list items 1, 3, and 5, enter "1,3,5".
Button operations in a list
When setting items in a list, operation buttons may be
displayed in the list depending on the menu.
In this manual, list item button operations use the
following convention.
Example:
Operating a button in the [Tally Assign] row for an item in
the list using the Home > Setup > Router/Tally > Tally >
Parallel Tally menu (19106.26).
1 Open the Home > Setup > Router/Tally > Tally >
Parallel Tally menu (19106.26).
2 Select the target parallel output port to set.
3 Press the [Tally Assign] button and select the type of
tally from the pull-down list.
When there is only one target item
Selection of the item is not required.
In step 2 of the procedure above, check that the target item
in the list is displayed on the menu screen. If the item is not
displayed, move the display position in the list.
In subsequent procedure steps, you can configure settings
by pressing buttons displayed in the row of the target item.
When there are multiple target items
In step 2 of the procedure above, place check marks in
individual checkboxes or in the Select All checkbox to
select target items.
Changes to the setting of one of the check marked items
will apply the same change in setting to the other target
items.
Changes to the setting of a parameter in the analog controls
section are applied only to the item selected as the target,
even if multiple items are selected. Also, you may not be
able to change other settings simultaneously.

Setting Parameters

Pressing a parameter setting button displays an analog
controls section on the right side of the menu display area
for adjusting parameters.
Parameter 1 to 5 buttons
Analog controls section
This section is comprised by a parameter display button
and up to five parameter buttons (numbered 1 to 5 from the
top).
The target button name/group name to set is displayed on
the parameter display button. If there are six or more
parameters, a page number ("1/2" or "2/2") is displayed on
the parameter display button, and pressing the button
switches between page 1 and page 2.
The parameter name and current setting value are
displayed on each of the parameter 1 to 5 buttons. Pressing
a parameter button displays an analog controls window for
setting parameters.
In this manual, parameter setting operations are
represented by the parameter button number and parameter
name.
For parameters on two pages, the number is in "page
number - parameter button number" format.
Example:
Parameters on one page only
No. Parameter
1 Width
2 Position
3 Density
Parameters on two pages
No. Parameter
1-1 Top
1-2 Left
1-3 Right
1-4 Bottom
2-1 H Phase
2-2 V Phase
40
Parameter display button
Adjustment
Width
Position
Density
Adjustment
Position of top edge
Position of left edge
Position of right edge
Position of bottom edge
Horizontal position
Vertical position