Editing A Snapshot Register - Sony XVS-G1 User Manual

3
In the register list on the left, select the target register
to set.
The attributes for the selected register appear on the
right.
4
In the attribute display area on the right, set the
attributes.
To add the cross-point hold attribute
1
Press the [Edit] button for [Xpt Hold].
The [Edit Xpt Hold] window appears.
2
Set the button for the target bus to the on state.
You can select multiple buses.
For the router region
Select a tab to change the level (Level 1 to Level 8) to
display.
Destination selection delegation buttons appear.
Select the target button row to set, and set the target
button in the [Xpt Hold] group to the on state.
If the [Xpt Hold Level x All] ("x" is 1 to 8) button is
set to the on state, all buttons for the displayed level are
set to the on state.
3
Press [OK].
To add the auto transition attribute
Set the [Auto Trans] switch to the on state.
To add the effect dissolve attribute
1
Set the [Effect Diss] switch to the on state.
2
Press the button on the right side of the [Effect Diss]
switch and enter a duration (number of frames) for the
effect dissolve in the numeric keypad window.
To add the auto play attribute
1
Press the [Edit] button for [Auto Play].
The [Edit Auto Play] window appears.
2
Set the button for the target channel to the on state.
You can select multiple channels.
Note
Only channels assigned to user regions can be
selected.
3
Press [OK].
To add the cross-point hold (DME) attribute
Set the [Xpt Hold] switch to the on state.

Editing a Snapshot Register

You can copy, move, and swap register data. You can also
rename, lock, and delete a register.
Copying, moving, and swapping registers between
different regions is supported between the following
regions.
• Between switcher bank regions (M/E-1 to M/E-5, P/P,
M/E-1 Sub to M/E-5 Sub, P/P Sub)
• Between DME regions (DME 1 to DME 4)
Copying a register
Notes
• An empty register cannot be copied.
• A locked register cannot be copied.
1
Open the Home > Register > Snapshot > Edit Register
> Copy/Move/Swap menu (18302.13).
A list of copy source registers is shown on the left, and
a list of copy destination registers is shown on the
right.
2
Press the [Select] button in the [Region] group on the
left.
The [Select Region] window appears.
3
Set the button for the copy source region to the on
state.
Select a tab to change the region to display.
[ME] tab: Switcher bank regions
[User] tab: User regions
[DME] tab: DME regions
[External Device] tab: External device regions
4
Press [OK].
5
In the list on the left, select a copy source register.
To select and copy multiple registers, place a check
mark beside the target registers to copy.
To select and copy all registers, place a check mark in
the Select All checkbox.
You can also press the [Select Register(s)] button and
enter a register number in the numeric keypad
window.
6
Press the [Select] button in the [Region] group on the
right.
The [Select Region] window appears.
7
Set the button for the copy destination region to the on
state.
222