Setting The Operation Mode When The Pattern Limit Is Released; Setting The Default Wipe Edge Softness; Enabling/Disabling Video Process Memory; Setting Key Auto Drop - Sony XVS-G1 User Manual

The cross-point hold operation mode is also applied to
snapshot attributes.
1
Open the Home > Setup > Switcher > Custom > Key/
Wipe menu (19103.43).
2
Select the target switcher bank to set.
3
Press the [Xpt Hold Mode] button and select a cross-
point hold operation mode from the pull-down list.
Key Disable: The cross-point hold button of the key
bus functions as a key disable set button.
When the cross-point hold button is enabled, the
cross-point selection information and the key
settings information are not applied, even when a
snapshot or effect timeline is recalled.
Key Dsbl with Status: Same as [Key Disable], but
also does not reflect the key on/off status.
Xpt Hold: The cross-point hold button of the key bus
functions as a cross-point hold set button.
When the cross-point hold button is enabled, the
cross-point selection information is not applied,
even when a snapshot or effect timeline is recalled.
Setting the Operation Mode When
the Pattern Limit is Released
1
Open the Home > Setup > Switcher > Custom > Key/
Wipe menu (19103.43).
2
Select the target switcher bank to set.
3
Press the [Pattern Limit Transition] button and select
an operation mode for when a pattern limit is released
from the pull-down list.
Auto: When the pattern limit is released, the
remainder of the transition is executed
automatically at a dedicated transition rate.
Manual: After the pattern limit is released, the
transition waits for the next operation, then
executes. The transition is not executed until you
operate the fader lever or press the [AUTO
TRANS] button.
Setting the Default Wipe Edge
Softness
1
Open the Home > Setup > Switcher > Custom > Key/
Wipe menu (19103.43).
2
Select the target switcher bank to set.
3
Press the [Wipe Edge Default] button and set the
following parameter.
No. Parameter
1 Soft
Enabling/Disabling Video Process
Memory
1
Open the Home > Setup > Switcher > Custom > Key/
Wipe menu (19103.43).
2
Enable/disable using the [Video Proc Memory] button.
On: Enable the video process memory.
Off: Disable the video process memory.

Setting Key Auto Drop

The "key auto drop" function automatically switches off a
particular key when you press a cross-point button on a bus
that is output as the background on a switcher bank.
1
Open the Home > Setup > Switcher > Custom > Key
Auto Drop menu (19103.44).
2
Select the target switcher bank to set.
3
Press the [Edit] button for [Key Auto Drop].
The [Set Key Auto Drop] window appears.
4
Place a check mark in the keys to set.
5
Press [OK].
314
Adjustment
Default value of wipe edge
softness