Chapter 23 Switcher Setup; Setting The Switcher Configuration; Setting A Switcher Bank; Setting The Operation Mode And Output For A Switcher Bank - Sony XVS-G1 User Manual

Switcher Setup
Setting the Switcher
Configuration

Setting a Switcher Bank

Assigning a Logical M/E
You can set how an M/E hardware block (physical M/E
block) of the switcher is referred to logically as an M/E.
You can assign M/E-1 to M/E-5 or P/P.
Notes
• When M/E split is enabled, you can configure each sub
block.
• It is not possible to assign the same M/E logical bank
more than once. The most recently assigned logical M/E
is enabled, and replaces the previous logical M/E setting.
1
Open the Home > Setup > Switcher > Config > M/E
Assign menu (19103.11).
2
Select the target physical M/E block/sub block to set.
3
Press the [M/E] button and select a logical M/E
(M/E-1 to M/E-5, P/P) from the pull-down list.
Setting Sub Block keys
When M/E split is enabled, you can configure the number
of keys assigned to each sub block.
1
Open the Home > Setup > Switcher > Config > M/E
Assign menu (19103.11).
2
Select the target sub block to set.
3
Press the [Number of assigned keys] button and select
the number of keys from the pull-down list.
When the system signal format is 2160P, you can
select 0, 2, or 4.
Chapter
When the system signal format is 1080P or 1080i, you
can select 0, 2, 4, 6, or 8.
Setting an SL key
An SL key can be used if the number of keys on a single
physical M/E block/sub block is four or lower.
Only one physical M/E block/sub block can use an SL key.
Note
To use the SL key function, the XKS-G1600 GPU Pack
(option) and XZS-G1620 SL Key License (option) are
required.
Also, when the system signal format is 2160P, the SL key
must be enabled.
1
Open the Home > Setup > Switcher > Config > M/E
Assign menu (19103.11).
2
Select the target physical M/E block/sub block to set.
3
Set the [SL Key] switch to the on state.
To disable an SL key, set the [SL Key] switch to the
off state.
Setting the Operation Mode and
Output for a Switcher Bank
Setting the operation mode
You can select from the following four operation modes
for each switcher bank.
Standard mode
Four outputs are assigned as follows (fixed).
Out1: Program 1 output
Out2: Preview 1 output
Out3: Clean output
Out4: Key preview 1 output
Multi program mode
Up to eight outputs can be used.
Out1: Program 1 output (fixed) is assigned.
306
23