Cueup & Play - Sony XVS-G1 User Manual

Status VTR
Local The REMOTE/LOCAL
switch of the device is
set to LOCAL.
Tape Out No tape is loaded.
Rec Recording
Cue> Cueing up in the
normal direction
Cue< Cueing up in the
reverse direction
Eject Ejecting cassette
Stb Off Stopped in standby off
mode
Stop Stopped in standby on
mode
Play Playing
FF Fast forwarding
Rewind Rewinding
Shtl> Playing in the normal
direction in shuttle
mode
Shtl< Playing in the reverse
direction in shuttle
mode.
Var> Playing in the normal
direction in variable
mode.
Var< Playing in the reverse
direction in variable
mode.
Jog> Playing in the normal
direction in jog mode.
Jog< Playing in the reverse
direction in jog mode.
Still Playing still image
a) Not supported for the Odetics protocol and AMP protocol.
Cueup & Play
You can save cueup & play settings, such as start point/
stop point timecodes, in an effect timeline register and then
recall the settings as required.
Cueup & play is configured using the device control block
or the menu. Recall a register in which cueup & play
settings are saved, and then control operation using the
utility control block or the menu.
Loop/recue
Loop/recue can be set for disk recorders that use the video
disk communications protocol.
Loop: Playback from the start point to the stop point, then
return to the start point and repeat playback.
Recue: Playback from the start point to the stop point, then
return to the start point and stop.
Disk recorder
Port is not open.
a)
No file loaded.
a)
Recording
–
–
–
–
Stopped
Playing
–
–
–
–
Playing in the normal
direction in variable
mode.
Playing in the reverse
direction in variable
mode.
Playing in the normal
direction in jog mode.
Playing in the reverse
direction in jog mode.
–
167
Notes
• Loop/recue are only available for disk recorders that use
the video disk communications protocol. Note that these
may not operate, depending on the connected device.
• To use the loop or recue function, it is necessary to
enable the function.
For details, see "Setting loop/recue" (page 337).
Notes on cueup & play
• Cueup & play cannot be configured for registers in
which a DDR/VTR timeline is configured.
• When using a disk recorder with cueup & play, if you
carry out the following sequence of operations, playback
may freeze on the frame of the start point.
- Press the [RUN] button to play to a point close to the
end of a file t stop playback t press the [RUN]
button again.
Perform the following operation if playback freezes.
- Recall another register t recall the target register t
press the [REWIND] button t press the [RUN]
button.
Setting cueup & play (device control block)
Set the start point, stop point, and loop/recue using the
device control block in device/frame memory/clip player
operation mode.
Selecting regions and saving/recalling registers are
controlled using the menu.
For details, see "Setting cueup & play (menu)"
(page 168).
Note
The start delay time cannot be set using the device control
block.
1
Press the [DEV] button.
The [DEV] button is lit amber, and the operation mode
switches to device/frame memory/clip player
operation mode.
2
Using the channel selection buttons, select the target
channel (CH1 to CH12) for operation.
You can select multiple channels. The first selected
button becomes the reference channel, and is lit green.
Subsequent selected buttons are lit amber.
3
Set the start point.
Play the target device to set using the device control
block and press the [START TC] button at the position
to set as the start point.
4
Set the stop point.