Setting Multi Program 2 Mode - Sony XVS-G1 User Manual

Use for M/E-1 main operations
Use for M/E-1 sub operations

Setting Multi Program 2 Mode

Setting multi program 2 mode flow
Set the operation mode for a switcher bank (see page 306).
Set multi program 2 mode.
Set the outputs of each switcher bank (see page 306).
Set the Out1 to Out8 configuration.
Assign a switcher bank (see page 315).
Set dedicated main and sub or share main and sub.
Select a cross-point assign table (see page 303).
You can select separate cross-point assign tables for main
and sub.
Inhibit key operation (see page 315).
You can inhibit key 1 to key 8 separately on main and sub.
Assign control panel buttons (see page 317).
You can set separate assignable buttons for main and sub
when using dedicated main and dedicated sub.
Assign the buttons for switching between main and sub
when sharing main and sub.
Setting control panel buttons when using
dedicated main and dedicated sub
You can assign the assignable buttons in the cross-point
control block, transition control block, and Flexi Pad
control block separately on main and sub.
For details about assigning buttons, see "Assigning
Control Panel Buttons" (page 317).
r
r
r
r
r
Setting control panel buttons when sharing main
and sub
You can assign the main/sub switching buttons ([MAIN]
button and [SUB] button) to the cross-point control block
and transition control block.
For details about assigning buttons, see "Assigning
Control Panel Buttons" (page 317).
To switch operation to the main side, press the [MAIN]
button, turning it on. To switch operation to the sub side,
press the [SUB] button, turning it on. To operate main and
sub simultaneously, press both the [MAIN] button and
[SUB] button, turning them on.
Note
Switch between main and sub after a transition has
completed.
Recalling a snapshot/effect timeline
You can also include the operation mode configuration
data when recalling a snapshot or effect timeline.
For details about settings, see "Setting the recall target for
an effect timeline/snapshot" (page 308).
Note
You can also automatically change the operation mode
configuration data saved in a register when copy/move/
swap operations are performed between main and sub
registers.
For details about settings, see "Changing main/sub
configuration data in multi program 2 mode" (page 213)
and "Changing main/sub configuration data in multi
program 2 mode" (page 223).
To change program output key assignments
When a snapshot or effect timeline is recalled on main or
sub, only the keys being used on main and sub, according
to the operation mode configuration data of the switcher
bank, become the recall target.
When [Recall M/E Config] is enabled in the Home > Setup
> Switcher > Config > M/E Config menu (19103.12), you
can also change the key assignment in the Common > Key
Priority/Key Assign menu of the switcher bank.
This section describes the M/E-1 menu as an example.
Note
The key assignment is linked to the Home > Setup >
Switcher > Config > PGM Config menu (19103.13)
settings.
182