Configuring Network Settings; Setting The Host Name Of The Switcher; Setting The Network Interface - Sony XVS-G1 User Manual

Configuring Network
Settings
Setting the Host Name of the
Switcher
Note
The host name setting is linked to the system name setting
in the System Configuration > SNMP > Common menu
(20701.11).
1
Open the System Configuration > Network > Network
Settings menu (20201.11).
2
Press the [Hostname] button and enter a host name (up
to 63 characters) using the keyboard.
3
Press [OK].
4
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button, check the message, then press
[OK].
5
Check the message, then press [OK].

Setting the Network Interface

You can configure the following six types of network
interface.
• Standard interface 1 (STD 1):
LAN 1 connector ( (see page 28) on rear of switcher)
f
settings
• Standard interface 2 (STD 2):
LAN 2 connector ( (see page 28) on rear of switcher)
g
settings
• Expansion interface 1 (OPT 1):
Network expansion 1 connector
rear of switcher) settings
• Expansion interface 2 (OPT 2):
Network expansion 2 connector
rear of switcher) settings
• Expansion interface 3 (OPT 3):
Network expansion 3 connector
rear of switcher) settings
• Expansion interface 4 (OPT 4):
Network expansion 4 connector
rear of switcher) settings
1) Can be used when a network card is installed in the PCIe slot of the
switcher.
1)
( (see page 29) on
r
1)
( (see page 29) on
q
1)
( (see page 29) on
p
1)
( (see page 29) on
o
357
The switcher LAN connector and configurable LAN types
supported by each network interface are shown below.
Network I/F Configurable LAN
STD 1 • Control LAN (Ctrl LAN)
STD 2 • Utility LAN 1 (Util LAN 1)
• No setting (Off)
OPT 1 • For control LAN redundancy
(Ctrl LAN Redundant)
• No setting (Off)
OPT 2 • Utility LAN 2 (Util LAN 2)
• For utility LAN 1 redundancy
(Util LAN 1 Redundant)
• No setting (Off)
OPT 3 • User LAN 1 (User LAN 1)
• No setting (Off)
OPT 4 • User LAN 2 (User LAN 2)
• For user LAN 1 redundancy
(User LAN 1 Redundant)
• No setting (Off)
a) Number corresponding to the description of parts on the rear of the
switcher.
To set standard interface 1 (STD 1)
1
Open the System Configuration > Network > Network
Settings menu (20201.11).
2
Select [STD1].
3
Press the [Edit] button.
The [Standard Network I/F 1 Settings] window
appears.
Note
The standard interface addresses can only be set
manually.
4
Press the [Address] button for [IPv4] and enter an
address using the keyboard.
5
Press the [Prefix Length] button for [IPv4] and enter a
prefix length in the numeric keypad window.
6
Press [OK].
7
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button, check the message, then press
[OK].
8
Check the message, then press [OK].
a)
Connector
f
g
r
q
p
o