Sony XVS-G1 User Manual page 51

Selecting a key fill signal/key source signal
You can select a key fill signal and key source signal using
the following methods.
To select a key fill signal
• Press a cross-point button in the cross-point button row
assigned with the key bus.
• In key bus mode and free assign mode, press and hold a
key bus delegation button in the function button section
and press a cross-point button in the 1st row.
• In key/AUX bus delegation mode, press a key bus
delegation button in the 1st row and press a cross-point
button in the 2nd row.
• On the Flexi Pad control block in key operation mode,
press and hold a key delegation button in the memory
recall section and press a cross-point button in the 1st
row in the cross-point control block.
To select a key source signal
• In key bus mode and free assign mode, press and hold a
key bus delegation button in the function button section
and press a cross-point button in the 2nd row.
• In key/AUX bus delegation mode, press and hold a key
bus delegation button in the 1st row and press a cross-
point button in the 2nd row.
• On the Flexi Pad control block in key operation mode,
press and hold a key delegation button in the memory
recall section and press a cross-point button in the 2nd
row in the cross-point control block.
Notes
• You can also select a key fill signal/key source signal in
the menu.
For details, see "Selecting the key fill/key source
signals" (page 79).
• You can also select a signal paired with a key fill signal
or select the key fill signal itself as the key source signal
automatically.
For details, see "Setting a key fill/key source"
(page 78).
Selecting a video signal/key signal
In free assign mode or key/AUX bus delegation mode, you
can select the video signal or the key signal of a V/K pair
using the [KEY] button assigned to the function button
section.
When a cross-point button is pressed while pressing the
[KEY] button, the key signal is selected. When a cross-
point button is pressed without pressing the [KEY] button,
the video signal is selected.
Information for the key signal or video signal, whichever
is selected, appears on the display on the cross-point
control block.
For a key source signal
The [KEY] button is enabled in operation modes that allow
you to select both a key signal and a video signal.
For details about settings, see "Setting the operation mode
of the [KEY] button in the cross-point control block"
(page 326).
When the [KEY] button is pressed, turning it on, and a
cross-point button is pressed, the key signal is selected.
When the [KEY] button is not lit and a cross-point button
is pressed, the video signal is selected.
Notes
• The [KEY] button cannot be used on the following
buses. Only the video signal is selectable.
- Key fill bus
- DME video bus
- Background A bus, B bus
• For a key source signal, you can also select a video
signal/key signal in the menu.
For details, see "Selecting the key fill/key source
signals" (page 79).
Selecting a DME video signal/DME key
signal
Press a cross-point button in the cross-point button row
assigned with the DME video bus or DME key bus to
select a signal.
When a cross-point button is pressed, the signal for the
front side of the image is selected. When a cross-point
button is pressed while pressing a DME video bus/DME
key bus delegation button in the function button section,
the signal for the back side of the image is selected.
Note
A signal for the back side can be selected when separate
sides are enabled. When separate sides are disabled, the
signals for the front and back sides are the same.
For details about setting separate sides, see "Setting
Separate Sides" (page 159).
51