P-Bus Trigger - Sony XVS-G1 User Manual

For details, see "Setting the operation of the first keyframe
when rewind is executed" (page 328).
1
Open the Home > External Device > P-Bus > Timeline
> Rewind Action menu (16102.12).
Rewind action settings information is displayed for
each device (0 to 23).
2
Select the target device for operation.
To select and set multiple devices, place a check mark
beside the target devices to set.
To select and set all devices, place a check mark in the
Select All checkbox.
3
In the [Action] group, select an action to set.
Off: Do not set an action.
Store: Set a store action.
Recall: Set a recall action.
Trigger: Set a trigger action.
4
Press the [Action No.] button and enter a register
number or trigger number in the numeric keypad
window.
When a store action or recall action is selected, set a
register number (1 to 4095).
When a trigger action is selected, set a trigger number
(0 to 15).
To test an action command output
Press the [Test Fire] button.

P-Bus Trigger

In a P-Bus trigger, you can output an action command to a
P-Bus device using the control panel and menu buttons.
Note
This can be configured only when a P-Bus trigger is the P-
Bus control mode.
For details about setting the mode, see "Setting the P-Bus
Control Mode" (page 322).
The following gives the buttons that can be used and action
commands that are output.
Utility control block
[RUN] button: Trigger 1
[REWIND] button: Trigger 4
[Effect Timeline Recall/Store] taskbar
[Run] button: Trigger 1
[Rewind] button: Trigger 4
[Effect Timeline Edit] taskbar
[Next KF] button: Trigger 7
[Previous KF] button: Trigger 8
[Recall/Store Register] window
[Recall] button: Recall
[Store] button: Learn
1) Only when displayed using the [Recall/Store] button on the [Effect
Timeline Recall/Store] taskbar or [Effect Timeline Edit] taskbar
Outputting an action command
This section describes output of the Recall command as an
example.
1
Press the [Recall/Store] button on the [Effect Timeline
Recall/Store] taskbar or [Effect Timeline Edit]
taskbar.
The [Recall/Store Register] window appears.
2
Select a P-Bus region.
On the [External Device] tab, set the [P-Bus] button to
the on state.
3
Press the [Recall] button.
4
Enter a register number (1 to 250) in the numeric
keypad area.
5
Press [Enter].
The Recall command is output.
174
1)