Sony XVS-G1 User Manual page 325

1
Open the Home > Setup > Panel > Custom > Operation
Mode menu (19104.61).
2
In the [Key Trans On Status] group, select a display
mode.
Disable: Lit amber during transition execution, and
goes off at the end of the transition.
Enable: Lit green during transition execution, and at
the end of the transition it is lit red if on-air or lit
amber if not on-air.
Setting the operation when an auto
transition execution button is pressed
during an auto transition
Note
Enabled using the [AUTO TRANS] button and a [KEY1
TRANS] to [KEY8 TRANS] button in the transition
control block.
1
Open the Home > Setup > Panel > Custom > Operation
Mode menu (19104.61).
2
In the [Auto Trans] group, select an operation mode.
Continue: Continue the transition.
Cancel: Cancel the transition and return to the
previous state before executing the transition.
Setting the next transitions to select using
the [ALL] button in the transition control
block
1
Open the Home > Setup > Panel > Custom > Operation
Mode menu (19104.61).
2
In the [Next Trans All] group, select a button to
include for the next transition.
You can select multiple buttons.
Bkgd: [BKGD] button
Key Priority: [KEY PRIOR] button
Key1 to Key8: [KEY1] button to [KEY8] button
Enabling double-press for the [BKGD]
button in the transition control block
When double-press is enabled, pressing the [BKGD]
button twice in quick succession selects all currently
inserted keys and removes them in the next transition.
1
Open the Home > Setup > Panel > Custom > Operation
Mode menu (19104.61).
2
In the [Bkgd Trans Btn Double Click] group, select
whether to enable/disable the double-press function.
Disable: Disable button double-press.
Enable: Enable button double-press.
Setting the operation mode of the [TRANS
PVW] button in the transition control block
1
Open the Home > Setup > Panel > Custom > Operation
Mode menu (19104.61).
2
In the [Trans PVW] group, select an operation mode.
Hold: Enables transition preview mode only while the
[TRANS PVW] button is pressed.
Lock: Pressing the [TRANS PVW] button switches
between transition preview mode and normal
mode each time the button is pressed.
Swapping the [AUTO TRANS] button and
[CUT] button in the transition control block
1
Open the Home > Setup > Panel > Custom > Operation
Mode menu (19104.61).
2
Press the [Auto Trans/Cut Swap] button.
On: Swap the [AUTO TRANS] button and [CUT]
button.
Off: Do not swap the [AUTO TRANS] button and
[CUT] button.
Setting the transition indicator display in
non-sync state
1
Open the Home > Setup > Panel > Custom > Operation
Mode menu (19104.61).
2
In the [Non Sync Fader Indicator] group, select a
display mode.
Normal: The transition indicator is lit when in non-
sync state.
Blink: The transition indicator blinks when in non-
sync state.
325