Chapter 4 Selecting Signals; Overview - Sony XVS-G1 User Manual

Selecting Signals

Overview

You can select a signal with the cross-point button rows in
the cross-point control block of the switcher bank.
1st row
2nd row
Display
Cross-point indicators
3rd row
4th row
Cross-point buttons
The button numbers are labeled on the cross-point buttons
of the cross-point control block.
Signals are assigned for each button number and you select
signals by pressing the buttons.
For details about assigning signals, see "Creating a
Cross-Point Assign Table" (page 301).
Shift button
A shift button is assigned to the rightmost button of each
cross-point button row.
Chapter
Depending on the control panel used, each button row has
24 buttons or 16 buttons.
This section describes control panels with 24-button rows.
Cross-point button rows
Function button section
You use the shift button to switch between the button
number in the shifted state and the button number in the
unshifted state in the button row.
The shift button has two operation modes.
Hold mode: Mode where the shifted state is selected while
the button is pressed
Lock mode: Mode where every time the button is pressed,
it toggles between the shifted state and unshifted state
You can also disable the shift button function.
For details, see "Setting the Shift Button" (page 302).
46
4