Sony XVS-G1 User Manual page 82

3
Set the signal to insert in the edge.
For a border, drop border, or shadow
In the [Edge Fill] group, select an edge fill signal.
Utility 1 Bus : Utility 1 bus signal
For details about selecting a signal, see "Chapter 4
Selecting Signals" (page 46).
Matte: Color matte
When the [Matte] button is selected, set color 1 using
the following parameters.
No. Parameter
1 Luminance
2 Saturation
3 Hue
For an outline
The key fill signal selected by the key is inserted in the
outline. The background signal is inserted in the rest of
the image.
For an emboss
In the [Emboss Fill] group, set the emboss color.
Matte 1: Color matte 1
Matte 2: Color matte 2
Set the following parameters.
No. Parameter
1 Luminance
2 Saturation
3 Hue
Setting soft edges
Note
When chroma key shadow is enabled, soft edge is
disabled.
1
Open the Home > M/E-1 > Key1 > Edge > Edge Type
Select menu (11101.21).
2
Set the [Soft Edge] button to the on state and set the
following parameter.
No. Parameter
1 Soft
Setting separate edges
When the edge type is Border or Outline, you can adjust
the width of the border/outline along the top, bottom, left,
and right edges separately.
1
Open the Home > M/E-1 > Key1 > Edge > Edge Type
Select menu (11101.21).
Adjustment
Luminance
Saturation
Hue
Adjustment
Luminance
Saturation
Hue
Adjustment
Edge softness
2
Set the [Separate Edge] button to the on state.
3
Set the [Border] button or the [Outline] button in the
[Edge] group to the on state and set the following
parameters.
No. Parameter
1 Top
2 Left
3 Right
4 Bottom
5 Density
Setting fine key adjustments
You can adjust the position of the top, bottom, left, and
right edges of the key source separately.
Notes
• When the key type is a key wipe pattern key, fine key
cannot be used.
• When the edge type is emboss, fine key cannot be used.
• When the edge type is normal, drop border, or shadow,
enabling fine key enables key drop.
1
Open the Home > M/E-1 > Key1 > Edge > Edge Type
Select menu (11101.21).
2
Set the [Fine Key] button to the on state and set the
following parameters.
No. Parameter
1-1 Top
1-2 Left
1-3 Right
1-4 Bottom
2-1 H Phase
2-2 V Phase
Setting an edge fill color mix
To mix color 1 and color 2 color mattes
When the edge type is normal, drop border, or shadow, you
can mix color 1 and color 2 when color matte is selected
for the edge fill.
1
Open the Home > M/E-1 > Key1 > Edge > Matte
Adjust menu (11101.22).
2
Set the [Mix Color] button in the [Edge Matte] group
to the on state and set the following parameters.
82
Adjustment
Top edge width
Left edge width
Right edge width
Bottom edge width
Density
Adjustment
Position of top edge
Position of left edge
Position of right edge
Position of bottom edge
Simultaneous adjustment of
position of left and right edges
Simultaneous adjustment of
position of top and bottom
edges