Setting Through Mode; Setting The Video Clip Function; Setting The Safe Title Area; Setting A Format Converter - Sony XVS-G1 User Manual

switch for one of the outputs to the off state and then
configure the outputs.

Setting Through Mode

When through mode is enabled, the input signal ancillary
data is passed to the output without change.
You can enable through mode for the following output
signals.
• AUX1 to AUX48
• Edit preview
Note
Through mode is enabled only when the signal formats of
the input signal and output signal are the same.
1
Open the Home > Setup > System > Output > Output
Assign menu (19101.41).
2
Select the target output to set.
To select and set multiple outputs, place a check mark
beside the target outputs to set.
To select and set all outputs, place a check mark in the
Select All checkbox.
3
Enable/disable through mode using the [Through
Mode] switch.
On: Enable through mode.
Off: Disable through mode.

Setting the Video Clip Function

1
Open the Home > Setup > System > Output > Video
Adjust menu (19101.42).
2
Select the target output to set and set the following
parameters.
No. Parameter
1 White Clip
2 Dark Clip
3 Chroma Clip
To return the settings to the defaults
Press the [Reset] button.
Adjustment
Luminance signal white clip
value
Luminance signal dark clip
value
Chrominance signal clip value

Setting the Safe Title Area

1
Open the Home > Setup > System > Output > Safe
Title menu (19101.43).
2
Select the target output to set.
3
Set the safe title area display method.
To display box 1
Set the [Box1] button to the on state.
Set the following parameter.
No. Parameter
1 Size
In the [Box1 Adjust] group, select an aspect ratio
(16:9, 14:9, 4:3).
To display box 2
Set the [Box2] button to the on state.
Set the following parameters.
No. Parameter
1 Size
2 Luminance
In the [Box2 Adjust] group, select an aspect ratio
(16:9, 14:9, 4:3).
To display a cross
Set the [Cross] button to the on state.
To display a grid
Set the [Grid] button to the on state.
In the [Grid Adjust] group, select an aspect ratio (16:9,
4:3).
In the [Grid Size] group, select a size (80.00%,
85.00%, 90.00%, 100.00%).
To return the settings to the defaults
Press the [Reset] button.

Setting a Format Converter

You can convert the signal format of an output signal.
When the system signal format is 2160P, you can use a
format converter on odd-numbered outputs.
When the system signal format is 1080P or 1080i, you can
use a format converter on outputs 1 to 12.
Setting the conversion format
You can set the signal format of an output signal to convert
by the format converter.
297
Adjustment
Size
Adjustment
Size
Luminance