Video Operations; Creating Video (Record) - Sony XVS-G1 User Manual

The frame memory output channels are shown on the
left.
To enable group mode
Set the [Group Mode] button to the on state.
When group mode is enabled, the frame memory
output channel display changes to [FM1/FM2].
2
Select [FM1].
3
Select content to recall.
The selected content is recalled and displayed on the
frame memory output channel.
Note
When group mode is disabled for frame memory
output channels and combined content is selected,
only content 1 of the combined content is recalled on
frame memory output channel 1.

Video Operations

This section describes the operation on frame memory
output channel 1 (FM1) as an example.

Creating Video (Record)

You can assign a frame memory source bus signal to a
frame memory output channel and then record to capture
video content and save it in frame memory.
Note
When the system is powered off, the content in frame
memory will be lost. Save any required content in content
storage.
For details, see "Saving content to content storage"
(page 130).
1
Open the Home > Frame Memory > FM1/FM2 > Clip/
Still > Record menu (13101.13).
To enable group mode
Set the [Group Mode] button to the on state.
When group mode is enabled, the frame memory
output channel display changes to [FM1/FM2].
2
Set the [Through] button for [FM1] to the on state.
The frame memory source bus signal is output on the
frame memory output channel.
Note
The output signal of the frame memory output channel
is delayed by one frame.
3
Press the [z] button for [FM1] at the position to start
recording.
4
Press the [x] button for [FM1] at the position to stop
recording.
The video content is saved in the folder specified in the
properties for frame memory source 1.
When a duration is specified in the properties for
frame memory source 1, recording automatically stops
when the specified duration has elapsed.
Note
If a frame memory is recalled using a snapshot while
video is being recorded, the recording stops.
132